Laptop Battery Battery Mark test software introduction
Usage:
Run on the premise that we have to charge notebook battery to full power, then the system shut down a number of related management systems, specifically what needs to close, see below.
Should first turn off the screen saver, if the screen program open, in the testing process, there will probably be a matter of time and activate the screen saver. Right-click on the desktop, select "Properties", "Screen Saver" This page will display program selected as the "Compaq Presario 2100 battery(compaq 2100 battery) (None)" and then click "Apply."
Next, click on the lower right corner of the page that "Power" button to enter the power management, the power use of the program all the items below be changed to "never."
Switch to the "alert" page, the words "low-battery alarm" and "a serious shortage of the battery alarm" two ticks were removed.
Switch to the "sleep" page, see "Start dormancy" whether in front of tick (now the vast majority of notebooks are able to activate the system sleep function), and if so, will remove the hook. Then click "OK", this power management has been closed.
If your screen resolution is less than Compaq Presario 2500 battery(compaq 2500 battery) the standard 1024X768 resolution, please adjust your first will be mandatory for 1024X768, if the resolution of 1024X768 and above do not have a. In addition, as Battery Mark to be displayed in full screen and the center continued to switch between the task bar will have adverse effects, the best taskbar always on top option to get rid of.
All those things are built-in power management program Windows settings, for some of the larger manufacturers will have their own dedicated power management program, essentially the same in real terms, as long as the principles in accordance with the above settings on it. (Of course, the above setting is only for the media, speaking in terms of evaluation, as individuals in the test, could use the vendor itself with a dedicated management procedures, the test proceeds should be slightly longer battery time point)
After the above series of settings, basically no other need to set, and then we can run the Battery Mark the (Start → Programs → Ziff Davis Media BenchMarks → Ziff Davis Media Battery Mark 4.0.1), but we can not have acute Disconnect the power Compaq Presario NX9010 battery supply, because after that there are "very long" and something to look at it.
The first thing we see is the License screen. At this point the page on the "Proceed" gray non-hits, we simply rolled the right of the scroll bar at the bottom, "Proceed" button will automatically become available.
Then the software will be prompted to fill in the names with the organization, where we can easily fill in, do not care.
After the confirmation page appears, click "OK" on it.
There are several options to make a few description:
1, Run (Start test)
2, Save results (save the test results)
3, Compare results (the results of comparison)
4, Help (Help)
Click Run, the software will detect the hardware platform to see if it meets the requirements, if you do not comply will not be able to continue running Battery Mark. (Black check mark that they comply with the minimum testing requirements; yellow X said that although the machine does not meet the minimum requirements, but Compaq Presario NX9000 battery I could still finish the entire test; a red X is the machine could not finish the entire test.)
Click "Next" will show Battery Mark the so-called minimum configuration requirements.
Click "Next" Also there is a whole page in English, where, Battery Mark will once again stressed that the restructuring resolution, as well as the hidden task bar problem. The bottom is the test still need to install any font requirements are generally No missing fonts (there are no missing fonts).
Feeling annoyed, and another one interface, at the top indicate our concern is not. In order to avoid the testing process by other programs affected, Battery Mark will automatically detect a running program, tied up, if the yellow X, does not have an impact.
Then this page has suggested that if the software runs on Hp F2299A battery Windows Me system, the first would be ME "System Restore" feature off, or will affect the test.
This time Zhongyu Ao is winding down, feeling than the march was also difficult, at this time point "complete" can then be tested (if it occurred in front of a red X, then the Finish button will be gray.).
Fainted, was again deceived affection for the software. This page is a test Battery Mark and machine's power management program is compatible, point Continue begin testing. (Due to the old models of power management compatibility, Battery Mark for a dedicated power management program compatibility somewhat less)
If the point of no big changes (only the bottom), 60 seconds later there Retry with the Cancel option, this time we should be bold press Cancel, otherwise, fall into this cycle of death.
Will pop up a warning prompt Battery Mark will be the case in the absence of power management is running, press F3 to continue, press Esc exit.
Press F3 to enter test selection window, where we can choose Conditioning Run and Life Test two kinds of test mode. Conditioning Run full-load mode, it calls three Hp F3172A battery engines: Graphics engine, Processor engine, Disk engine, simulation of the workload in a major state of laptop time. Compared with the Conditioning Run mode, Life Test Mode and Multi-engine used a Think engine, mainly in the practical application of simulated notebook among the situation. Under normal circumstances, Life Test Mode Conditioning Run mode longer than the 30% ~ 40%.
Choice test items to be carried out, according to F3, a warning will appear (whether in the absence of power management in the conduct test). At this point disconnect the power adapter, and then press F3 to officially begun.
If not carefully choose the wrong test items, need to quit, then press F3, then press F3 again to confirm exit. To re-select the right test items to test (to remember the first power full of the first).
As for testing time should be determined depending on the specific model. Like I previously measured the Sony TX, C mode, ran a total of more than 4 hours, while the running time of L mode, sleep a night, woke up the next morning, no finish, a full 7 hours. However, under normal circumstances, even if the power be bigger (or smaller battery capacity), the general must come to an hour, so we can go to making a cup of coffee, Bian Hebian look set drama, after reading again, it is estimated Hp Pavilion ZT1000 battery almost nine.
Note:
1, in the Life Test test, generally the screen brightness to adjust to a half (some models use the battery when the screen brightness will automatically be reduced, this time without Zaiqu their adjustment), if the notebook comes with special software, it can be transferred to the best battery performance mode. The Conditioning Run mode, then best to crank up the brightness of the screen, special-purpose software is set to best performance mode.
2, Battery Mark have certain memory requirements, if a relatively low memory crash situation may occur, we recommend at least 64MB RAM or more Win98 systems, Win2k system, 128MB or above, WinXP 256MB or more to avoid the crash to happen.
3, pay attention to the settings should be modified, such as the power use of the program, alarm, status bar, screensavers, sleep, have to double-check, if missing, it will only affect the accuracy of test results.
4, sometimes occur Battery Mark is running Baocuo, the user need not worry as long as the re-start time is like, you can then cut in front of the test to continue.
5, due to the number of lithium battery charging and discharging is limited, and occasionally run what will not have much effect on life Hp Pavilion XZ200 battery expectancy, but if too frequent use of Battery Mark test, then, will affect battery life.